Quick Links
Guidelines for Authors
One of the goals of the Journal is to bring the Academic and Industrial Research community’s closer. The Journal is soliciting original high quality research papers on all aspects of Advanced Computing Techniques.

The Notification of Acceptance in ONE/TWO WEEKS after submission of Research article .The article can submit in single column format for review.

PAPER FORMAT :( Ms-Word and Adobe PDF)

  • LENGTH: Allowed a total of 7 pages for document (including all figures, tables, and references). Additional pages cost Rs.300/ $20 per page with a maximum of 6 pages.

  • PAPER TITLE: The main title (on the first page) should begin 1-3/8 inches (3.49 cm) from the top edge of the page, centered, and in Times 14-point, boldface type. Leave two 12-point blank lines after the title.

  • AUTHOR NAMES AND AFFILIATIONS: Author names and affiliations are to be centered beneath the title and printed in Times 12-point, non-boldface type. Multiple authors may be shown in a two- or three-column format, with their affiliations italicized and centered below their respective names. Include e-mail addresses if possible. Author information should be followed by two 12-point blank lines.

  • MARGINS:Any text or other material outside the margins specified below will not be accepted. All printed material, including text, illustrations, and charts, must be kept within a print area of 6-1/2 inches(16.51cm)wide by 8-7/8 inches(22.51cm) hight. All text must be in a two-column format. (Except abstract and followed by two-12 point bold lines).Columns are to be 3-1/16 inches(7.85cm) wide,with a 3/8 inch (0.81cm) space between them.Text must be fully justified. A format sheet with the margins and placement guides is available as PDF file . It contains lines and boxes showing the margins and print areas. If you hold it and your printed page up to the light, you can easily check your margins to see if your print area fits within the space allowed.

  • TYPEFACE: We strongly encourage authors to use Times-Roman 10-point font. If a font face is used that is not recognized by the submission system, your proposal will not be reproduced correctly. No font size smaller than 9 points should be used anywhere in your paper, including figure captions. Avoid using bit-mapped fonts if possible. True-Type 1 fonts are preferred.

  • MAIN TEXT: Type your main text in 10-point Times, single-spaced. Do not use double-spacing. All paragraphs should be indented 1/4 inch (approximately 0.5 cm). Be sure your text is fully justified—that is, flush left and flush right. Please do not place any additional blank lines between paragraphs.

  • FIGURE AND TABLE: High quality, camera ready figures and/or tables are required. Captions should be 10-point boldface Helvetica (or a similar sans-serif font). Initially capitalize only the first word of each figure caption and table title. Figures and tables must be numbered separately.


      FIRST-ORDER: For example, “1. Introduction”, should be Times 12-point boldface, initially capitalized, flush left, with one blank line before, and one blank line after. Use a period (“.”) after the heading number, not a colon.

      SECOND-ORDER: As in this heading, they should be Times 11-point boldface, initially capitalized, flush left, with one blank line before, and one after.

      THIRD-ORDER:Third-order headings, as in this paragraph, are discouraged. However, if you must use them, use 10-point Times, boldface, initially capitalized, flush left, preceded by one blank line, followed by a period and your text on the same line.

  • FOOTNOTES: Use footnotes sparingly (or not at all) and place them at the bottom of the column on the page on which they are referenced. Use Times 8-point type, single-spaced.

  • REFERENCES: List and number all bibliographical references in 9-point Times, single-spaced, at the end of your paper. When referenced in the text, enclose the citation number in square brackets, for example [1]( For more than one citation [1,2]).Where appropriate, include the name(s) of editors of referenced books.

      [1] V. Daneul, C. Joey, and A.B. Kalam , “Article Title”, Journal/Proceedings, Location,month,pp.1-10,year.

      [2] V. Daneul, C. Joey, and A.B. Kalam , Book Title, Publisher, Location, publication year.and Biography of Authors with photograph.